IP Complete

I realize that I haven't posted in a while, but I have been working on the aircraft. The IP is complete now. I finished glassing and then added the stiffeners. Here you can see them cut and laid out. I might add that I shortened the vertical stiffeners when I realized that they were too long:

I used 2x4's to hold the pieces in place while 5-min epoxying them into place:

All stiffeners in place w/ micro along the edges:

For the electrical conduits I would glass first the single ply on the upper surface, allow it to cure, and then do the 2 plies for the conduit itself as shown below:

Finally, the IP completed: